Distilled Water and PH???

I bought some walmart distilled water. The PH tests at about 5.5 I would guess from the chart. Should I use it like this or do I need to PH UP it???

u need 6.5 - 6.8....but if you see PH is a disaster for me

your PH meter is way off i have that same water and the PH is 7

Actually distilled water has a low pH because of the atmospheric gases in it, so depending on temperature (temperature affects solubility of gases) at the time of bottling, how long it has been open, etc. you might get diff readings.
Anyway if you're using distilled water #1 step is calmag plus.
Then add nutes. Then test pH.
Most growers should be fine with their tap water BTW. Except for sulfur guy... you've got a problem :D

Thanks for the quick responses!

Can you tell me what the calmag plus does for me???

I have used tap water in the past... The water here is pretty hard though and has lots of white specks in it if you let it sit overnight... ???

Also, I am just using the dropper PH tester... 4 drops in 1/2 of the small bottle, shake and match to chart.

I also had someone else recheck it and it looks like 5.5+...

SHOULD I LEAVE IT or should it be 5.8-6.0??? Wont the PH rise as it is in the dro buckets?

PH is 5.0

I/we have checked and rechecked it....

Should I add PH UP??? I have always used tap water in the past...

YO! PH is 5.0 after nutes. Add to 5.8???

Yo!

Calmag gives back only the good stuff that was removed in the distillation process. Your plants NEED calcium to be healthy!

If you get little white specks in your tap water WOW it's REALLY hard!!!

Another nice thing about adding calcium is that is does raise the pH a touch.

Nutes/supplements/calmag 1st then pH up.

Yo.

Thank you Stinky. And I hope you get to set the attic back up soon:)

I wish... but the space is compromised...
I doubt I would ever be safe using it again.
I think once you bail from a spot, whatever security (theives, the law, whatever) isuues you had still remain there... like eternal bad karma for your grow.
We'll see what the future holds. :D

YO, u need to add 6 is higher than 5obviously dont need to take away ph..... ADD it

i would add the calmag after you add PH up, calmag doesnt do anything to effect PH so this is normally added after all is done, a tip from Zandor

I did my last grow at 5.8, but I was in a different property that didnt have this nasty water... That is why I went to the distilled.

I think I am going to use the tap water and add my dechlorinator. Then my nutes GH 3part nutes + any additives, then PH to 5.8 (either UP or DOWN, since Im not a total Dumbass). Then I will just let my water sit overnight as usual. The particles go to the bottom... I just wont use the bottom water.

Or I will buy some calmag today!

Everyone satisfied???

My nutes list is on my top thread/grow log. They are all in the GH family.