Cabinet, 1000W Hydro-DWC SCRoG White Widow
It has finally happened… Turtle has gone hydro!
After much delay (waaay too much, in fact!), it’s ON!
We’re growing two White Widow clones, from a known female plant. It’s inside a cabinet (which sits inside a closet), that measures 20inches by 40inches in its base, and 48inches tall. Because of height restrictions (and newb dreams of grandeour), we’re doing a SCRoG (Screen of Green). Inside the cab, we’re running two bulbs: a 400W MH, and a 600W HPS. Both of them, inside a cool tube (more or less “cool”).
For vegetative growth, we’ll be using only the Metal Halide… when 12/12 (flowering) comes around, we’ll run both MH and the High Pressure Sodium bulbs. That will give us a total of 1000W for the cabinet. I’m aiming at keeping the bulbs from 12 to 14 inches away from the screen.
For exhaust, we’ve got a 300CFM NuTone fan on the top of the cabinet, pulling air OUT. We’ve got a 4” dryer duct fan hooked up at the bottom of the cabinet, as a passive intake. The cabinet inside is Mylared all the way, except the bottom “floor”.
HYDRO setup::: I decided to go the simplest hydro route, and in my opinion, that’s DWC (Deep Water Culture). So, we’ve got one 5 gallon bucket per plant, two plants, and a third 5 gallon “reservoir” bucket”. All three buckets are interconnected, and a small pump is flowing the water through all three.
For the all important hydro readings, we’re running a Hanna meter… we can measure EC/TDS, ppm, pH, and the temperatures of the hydro solution. ( hope I got that right). Anyway, the Hanna meter has two probes, both of which have been located in the reservoir bucket.
Oxygen for the roots::: At the present, we’ve got only one dual-outlet aquarium air pump, running two air stones… one air stone per bucket. Future upgrades (ASAP) are a second air pump, with two more air stones… TOTALS: one air pump + two air stones for EACH bucket. That should give nice bubbles…
NUTRIENTS (“nutes”)::: We’ll be using General Hydroponics (GH) 3-part series nutrients… FloraGrow, FloraMicro, and FloraBloom. Also, GH pH up/down. For WATER we have a RO+DI (Reverse Osmosis + DeIonization) water filter.
NUTE ADDITIVES and STUFF::: We’ve got SuperTHRIVE (basically “a must”). Also, CalMag PLUS (with RO water, basically also “a must”). Later things, I think we have Bloom Booster or something like that…
….
Clones are looking great… they’re really growing during these hours. They’ve been in the hydro setup for aproximately 24 hours (actually, less), and their roots have JUMPED! I hope I see some equally impressive growth rates with the upper side of the plants.
Any and all inputs and suggestions are greatly welcomed…
Thanks for stopping by.
-turtle420 :cool:
.
Cabinet, 1000W Hydro-DWC SCRoG White Widow
HYDRO READINGS:
15 gallons of tap water
INITIAL READINGS:::
307 μS
154 ppm
8.05 pH
81.8 °F
Using GH instructions on the back of the bottle, for the “Vegetative Growth Stage”
FloraGrow
3TSP/gal
15 gallons total
= 225mL of FloraGrow
Instead of 225mL, we’ll be putting in 150mL of FloraGrow. 150/225= 0.67 = 67%
FINAL amounts put into 15 gallons of water:::
150mL FloraGrow
100mL FloraMicro
50mL FloraBloom
READINGS 1:10am
82.0 Farenheit
1872 uS
934ppm
6.83pH
READINGS 2:26am
Relative Humidity = 79%
Air Temperature = 83.6 Farenheit
82.1 Farenheit
1909 uS
955ppm
5.80pH
READINGS 7:30am
Relative Humidity = 77%
Air Temperature = 85.2 Farenheit
82.3 Farenheit
1940 uS
970 ppm
6.19 pH
READINGS 12:20pm
Relative Humidity = 75%
Air Temperature = 94.8 Farenheit
83.5 Farenheit
1975 uS
987 ppm
6.16 pH
READINGS 5:15pm
84.7 Farenheit
1951 uS
976 ppm
6.12 pH
READINGS 8:02pm
Relative Humidity = 75%
Air Temperature = 85.6 Farenheit
84.1 Farenheit
1967 uS
983 ppm
6.04 pH
NOTE::: When you see Farenheit, and it doesn’t say “Air Temperature”, then it’s the temperature of the hydro mix.
I've attached a chart of nutrients/pH values. It can be found in the FAQs, @
http://boards.cannabis.com/showthread.php?t=25080
Cabinet, 1000W Hydro-DWC SCRoG White Widow
nice turtle..
how much were those buckets?
Did you make that system yourself?
: )
Cabinet, 1000W Hydro-DWC SCRoG White Widow
Good Work turtle, impressive, no wonder you've been so quiet. The data charts are pretty too, nice colors
Cabinet, 1000W Hydro-DWC SCRoG White Widow
Wuhuuu!!!! Things to reply!!! :)
Quote:
Originally Posted by Garden Knowm
nice turtle..
how much were those buckets?
Did you make that system yourself?
: )
Yeah, made it my self. Got a couple of issues that need fixing (addition of another air pump, and installing bigger diameter hoses).
I plan on writing up a more-or-less how I did it.
Cost of buckets = I think it was $5 for a bucket and a lid. They're good, because they're thick plastic, reinforced at the bottom and top, light doesn't shine through them... and, again, $5. :)
Thanks for the post gK.
Quote:
Originally Posted by cactusman23
Good Work turtle, impressive, no wonder you've been so quiet. The data charts are pretty too, nice colors
Thanks for posting CactusMan...
QUESTION for you: How do you... um... have "relationships" with women? Or do you find CactusWomen?
LOL!
I'm just kiddin' man... :)
I've been quiet because I've been time-less... not enough time to... to go into my beloved boards.cannabis.com
The charts are from a FAQ Zandor wrote up... I didn't make them. In any event, they're usefull information. Probably what gK recites every time he wakes up in the morning...
Cabinet, 1000W Hydro-DWC SCRoG White Widow
There is a cactuswoman in my life and our relationship is a bit prickly, but hey it works for us.
Again my compliments, and to everyone else out there, what are ya waiting for, start posting!
Cabinet, 1000W Hydro-DWC SCRoG White Widow
very , very nice turtle i take my hat of to you, very nice indeed.
Cabinet, 1000W Hydro-DWC SCRoG White Widow
Cabinet, 1000W Hydro-DWC SCRoG White Widow
CactusMan...
Good for you! (regarding CactusWoman).. lol ! :D
PostManDave...
Thanks for the kind words... :)
Villui...
Thanks for dropping by buddy ;)
............
PROBLEMS???
I don't know... maybe....
Ok, I'm uploading some pics... three of them are of the biggest clone/plant, and the 4th one is of the second clone/plant.
Both plants have their leaves curling inwards... in a down-then-inward shape.
They're not dying... I can see that... but, maybe they can be in better shape???
There's a pic of a close-up of one of the leaves... the leaf is slightly "lighter colored" than the lower leaves...
Again guys, thanks for all the help. I realize that they ARE NOT dying, but, maybe I can get some pointers from the experienced? (And the inexperienced too!!!)
Latests HYDRO DATA:::
YESTERDAY @ 8:02PM
6.04 pH
84.1 Farenheit
1967 uS
983 ppm
Relative Humidity = 75%
Air Temperature = 85.6 Farenheit
TODAY @ 10:45AM
1952 uS
84.7 Farenheit
976 ppm
6.04 pH
Relative Humidity = 69%
Air Temperature = 86.2 Farenheit
....
I added some pH down, and before I left them, the pH "more or less" stabilized around 5.75
Other than that... that's it!
Thanks for stopping by everybody! :D
Best regards to all,
-turtle420 :cool:
.
Cabinet, 1000W Hydro-DWC SCRoG White Widow
Couldnt Help Turtle but Stuff is looking nice:thumbsup:
I love ur setup its nice and neat, also it looks like u put some hard labor in making that perfect:upsidedow Again nice JOB :thumbsup: So how long are you veging for and where are those WW from?