Just put it in a pan of boiling water or what?
Printable View
Just put it in a pan of boiling water or what?
No no no the best way is this:
Materials:
1. get a large bowl big enoiugh to submerge your piece in.
2. Fill it with hot water
3.can with a plasitc top. ex. pringles can, coffee can
4. coffee filter
5.Paper clip
Procedure:
take your piece submerge it in the bowl of hot water. leave it there for like two minutes take it out and pour out all the water back into the bowl. there should be black resin coming out. now take the paper clip and scrape the bowl. repeat this process 3 to 5 times or untill u have a lot of black resin in the bowl of water. take the can and cut the bottom out of it so it is just a cylinder with a plasic top. now cut the center out of the plastic top. take the coffee filter and put it on the top of the can and secure it by snaping the plastic top on it. so it should be a can with a filter on one end held in place by the top. now take the device u made out of the can and place it in the sink or somewhere with drainage. pour the water in your bowl through the filter slowly. you should see the resin colecting on the filter. then un hook the filter and kinda form all the pieces of resin together making one big piece of resin. and there you go smokable resin.
http://boards.cannabis.com/recreatio...sin-guide.htmlQuote:
Originally Posted by Fore20
Cool, thanks casper and slipknot
I hate smoking resin, but hey you gotta do what you gotta do.
Quote:
Originally Posted by 1chronic
Why, I thought it gets you higher
actually, what i've found to be the best scraper is a piece of a coat hanger. go get a wire coat hanger that is not too thick and a pair of wire cutters. next cut the wire towards 1 of the ends of the long part. then cut it again 5 inches down. take that 5 inch piece of wire and make a small bend on 1 end to make a scraper hook thing which you can reach to the edge of the insides. if you use this it will be easier to scrape the resin off the tool. hope this helps.
Now after you have gotten the resin, you may notice that your fingers are stinky and black! YUCK! Here's how to get the stuff off- plain old soap and water won't cut it. Take a couple of squirts of liquid hand soap and hand sanitizer- no water. The two combined really cut the resin. When your hands look clean, rinse them under warm water. Repeat if necessary.
The resin I get from my vaporizer is sticky, so I cut it with finely powdered shake. I just rub it through a wire mesh tea strainer. It's a hassle since the strainer is small, but I don't need much. It makes the resin easier to handle and also it burns better. - Granny:hippy:
boil your bowl in water and pour the black water through a screen. smoke the resin
soak it in hot water for like 2min and scrape it with a knife.