Printable View
Way cool offer P/C ,:thumbsup:Quote:
Originally Posted by PharmaCan
I already orderd a 3rd. Mine are "Cool Star" cheapies 2 - 27" long 6" dia. , the 3rd I just ordered is 31" long 1 for $80.00 to put in the middle of the 2- 27"s . w/ 7ft of cooltubes we wont need to waste time w/ the intelitrack mover anymore and hopefully cut down cycle time and maybe increase yield too .
Peace Bro.
Crispi :stoned:
OK - Well how about a Pac Trac snow cat for $1,000? If I get the snowcat out of the garage I'll have more room to store my cool tubes. :DQuote:
Originally Posted by xcrispi
I just measured my tubes - they're 27.5 inches. As I recall, they weren't horribly expensive - about the same as what you paid. I just replaced all my cool tubes with Daystar reflectors. I wasn't happy with the way the c/t's direct light - too much going off to the sides instead of straight down. Maybe you don't notice since you're down low, but the c/t's in my cab were eye level with me and they really glare out the sides. So now the plants are getting more light and it's a lot easier on my eyes to work on the plants.
PC :smokin:
hey crispi every new pic you post amazes me, someday were gonna smoke together, though you probably wouldnt like my herbs and spices
Hey Xcrispi - do you have any sort of screens over the 3/4" fittings in the buckets? I'm in the middle of getting mine back online and I'm putting in 3/4" feeds also but I'm somewhat worried about them getting clogged with roots. What do you think?
nice setup and plants u got going
Hey crispi nice set up man I want to grow up and be like you. id give you some rep but its not working. Keep it up man and stay high peace.:rasta::rastasmoke::smokin:
Hey Doco ,Quote:
Originally Posted by doco
No screens on the 3/4 inch fittings . I tried it once w/ the green flood table fittings = bad deal . the 1/2 in. I.D of the fittings was reduced down to 3/8 in. I.D and plugged up , roots grew into screens too .
The only prob. I've had using the 3/4 fittings was the system recirculates so fast that the entire rootball gets pushed to 1 side of the bucket and slows the rate in which the pump bucket gets refilled at so we had to slow down the lil via aqua pump to about 50-60 % . We spin the buckets 90 deg. every day , or lift em up part way just incase roots are indeed growing into the fittings .
Peace Bro.
Crispi :jointsmile:
Been a while w/o any updates ,
Nexus and an Indica dom. cottonandy x were chopped at 8 weeks .
The Church and a BlueberryCottoncandy were chopped at 9 weeks . -> pics.
More coming -> :)
Shit finally got my Internet hooked up!!!!!! That pic of the entire plant is nice.
Is it the nature of that strain not to be filled with fan leaves or do you prune a lot off? My shit is outta control with fan leaves, but I only prune leafs under the canopy that are dying. I have enough room. I have 4 plants centered 2 foot square to the center of a room 5x6x7. Gottem in 5 gallon buckets sitting on a small stand, drain in the bottom that goes to shared res. have lines from res to plants with a few drip stakes for each. I am also at about 5 weeks flower using latewoods GH 3part formula.
10 Weeks in today ,
All the sativa dominant kiddies are still plugging along good .
1 - Weedhounds mix - in dirt is almost done .
2 - Sat. Dom. Cottoncandy / 1 hydro -1 soil
2 - BlueberryCottoncandy in hydro
Need to take trich pics of Weedhounds mix , and BlueberryCottoncandy - they're probably ready to chop = more pics later .
Here is my fav. plant so far this grow . A HUGE Cottoncandy x in hydro - shes got a week or 2 more to go . Bettin on 1.5 lbs from just her . :thumbsup:
We also made a new bubble cloner / seed starter like 1 I think Opie Yutts' to start the next batch all to be all grown in soil .
Peace all.
Crispi :jointsmile: