what i did was cut cardboard to fit the wall, then cut the mylar to the card board and you can glue it or stretch tape it on, now you can remove the walls if needed and clean them and place them back in 10min flat.
invision Reviewed by invision on . how to fit mylar? would the best way to fit mylar be to glue it directly to the wall or would it be better to tack it to a frame? i also had a bit of an idea and was wondering if its ok to do this: make a circular reflector out of card or thin mdf cut to extend over the tops of the plant pot by a few inches. cut a hole in the middle large enough for growth and for watering, then cut a line from the middle to the outer edge so that it can be removed. then cover with white paint or mylar. would this benefit the Rating: 5