Just take a sharp knife and cut the tip of the part off..where the black part is..make sure you wear a oven mitt or something while your holding the lightbulb. Do it gently it should take 5-10 minutes or less depending on how sharp the knife is. A bread knife works best.

Then. take a cap from a bottle that will fit, if not you can just tap it.

Cut two holes in it and either put glass or hard plastic tubes or metal tubes. Don't use a straw it's too thin and it'll heat and melt and you'll get all kind of plastic vapors in yorur mouth esophagus and lungs.

Enjoy.

Oh yeah..You can just go to a smoke shop and buy a SHIT pipe that'll work. Get a vaporizer bong or a G BONG NOT A GRAVITY BONG A METH BONG..and it'll work all the same.
STDzRus Reviewed by STDzRus on . light bulb vaporizer has anyone ever made one? if so how did u use it. What i did was cleaned out all the shit inside and then i put the bud in there, then i covered it will a paper towel and then i put the flame to the bottom and every once in a while i would shake the bud a little bit and then i could see like smoke and i am guessing that was THC? but then when i figured there was enough for a monster hit i took the paper towel away from the top and then put a bic pen (without the ink shit so it was just like a Rating: 5