hey everyone, thanks for the info. i haven't been here to check this thread for a bit but it's the weekend again so i'll be around . i have been researching and i think i am gonna build and aero table very similar to the aerflo2 systems. there is a great howto article in the new cc mag. the only thing i can't seem to locate on the internet or locally are hydra connectors.

latewood, you say you would only do 5-6 plants in a 4'7" x 4'7" space with 1.4kw hps lighting? how long would you veg them. i grew 4 plants in my 2ftx4ft 400hps scrog and veg time on them to fill the screen was usually 4-6 weeks from rooting. i was thinking about 20 - 30 plants vegged for 3-7 days to fill the new space. at least that's how it would work with my soiless grows. i just can't see 5-6 plants filling the space unless i vegged for alot longer than a week. although i have little to no hydro experience and you seem to be the expert here so i definitely value your advice . you recommended about 16 plants. i could build a table that has 4 rows of 4 plants but i could always build a table that has 4 rows of 5or 6 plants each and just leave a few sites empty if it turns out to be too muh after i get through the 1st grow. i still have a couple months too work all this out so i welcome any and all thoughts on the matter.
justaseed Reviewed by justaseed on . longtime dirt farmer exploring hydro options i know my way around the grow room but have always done. soil or soilless grows. i am looking at my options for going hydro. the spaces available are 2ftdeep x 4ft long by 6ft high for veg lit by 8 4ft agrosun full spectrum t12's and for bloom a 4'7" x 4"7" x 5'6"tall lit by 1.4kw hps. i am thinking of maybe a simple dwc tub in the small chamber for clones and a very short veg. for the flower room i am thinking about something like the aeroflo2 36site or some sort of nft system either diy or Rating: 5