Here is what worked out for me with atleast 98% success rate,first cut a clone or how ever many as you want,but remember to many cuttings may stump or cause your main plant to become sick! so cut a few but not over kill!,first cut the clone straight off the plant who cares if it is a 45 degree cut or not,because after I cut my clone off the main plant,I then re-cut the clone but this time under water on a 45 degree,I then take my very clean razor blade and scrape the side of the bottom of the stems until I break through the first layer of plant tissue,,just scrape lightly until the green stem breaks down to reveal the white core inside(don't know the proper name but anyway's do all of this while clone is still under water and do it about a 1/2 inch or so,this will allow the roots to form much faster!,,after you do this then roll your stem of the clone in rooting powder,the stick the clone in a mixture of lots of perlite,vermiculite,with a little soil ,water the medium and also foilager feed water to the leaves,spary the leaves lightly maybe twice a day,best results under humity dome,if you don't have one get a clear plastic bag perhaps zip lock bag and place it over the pot,lift the bag once a day or so to allow fresh air,here is a test let the leaves branch's droop down for a little while then spray the leaves with ph balanched water and the leaves will,stand up and look real fresh looking,anyhow clones will have to be sprayed a couple of times a day keep flourcent lights atleast 4 to 6 inch's away depending on your heat,remeber this as well if you overdue spraying the plants to much root development may slow down alot simply becxause it's being feed water through the leaves,so don't over do it.....let the clones droop from time to time this means they are desparate for water therfore will force itself to root,.....................it works well for me,I cut 35 clones a couple of weeks ago and only lost 1!..............................good luck.
bruiser Reviewed by bruiser on . try cloning and fail it alrite i try cloning and fail it did not root at all but just die i dont know what i did wrong can sumbody plz tell me I cut it at a 45 dergree angle and then i put it in water then i apply the rooting powder and i use normal soil and put the cutting in i dint pack the soil too tight either also I had about 80 watts of light on it but it wanst direct Rating: 5