Kief Help

[ToDrunkToFish]

I was lookin at NoChowders post about hash, ive tried it once before but after 2 days of very carefull handling it broke apart again. And I lost quite a bit here and there.

I only did that once, I coulda done somthin wrong but now I got 2x mayby even 3x of what I did before and I dont want it to happen again.

Ive seen ways to 'heat' it with a lighter. And this makes it solidify better so I hear. So my question is

Whats the best step to heat it while also usin NoChowders guide?

Or whats another good way to make some hash, in a noobs shoes.

ToDrunkToFish Reviewed by ToDrunkToFish on 02-05-2007. Kief Help I was lookin at NoChowders post about hash, ive tried it once before but after 2 days of very carefull handling it broke apart again. And I lost quite a bit here and there. I only did that once, I coulda done somthin wrong but now I got 2x mayby even 3x of what I did before and I dont want it to happen again. Ive seen ways to 'heat' it with a lighter. And this makes it solidify better so I hear. So my question is Whats the best step to heat it while also usin NoChowders guide? Or Rating: 5

[ToDrunkToFish]

Knowone knows? I plan on doin this tonight here in an hour. I just need a step!

[Nochowderforyou]

Ah yes, this is a common problem with some people.

If you want to heat it up to make it more solid, you can use the oven. Don't use a lighter as it will burn away.

To use an oven, what you do is you take the kif that is already rolled up tightly in a bag, take a piece of paper, and wrap it tightly around the kif in the baggie. Make sure it is completly covered with the paper. Once it's wrapped up, you just tape it shut.

Now, pre-heat your oven to 175degC. Don't use Farenheit as cannabis has a vaping temp of 220degC.

Take that kif now wrapped in the plastic and paper, and soak it down with water really, really well. Ensure the kif is 100% selaed no water gets inside.

Take the wet kif package, and place in the oven for 15minutes. When you take it out, as soon as you can, start applying mass pressure on the package. A hammer works, but use a rolling pin or something similair in this situation, if you can. You will feel the package is kind of soft, like gel, that is a good thing. Apply mass pressure on both sides of the kif package to press it.

Then put it in the fridge to cool down. Cool it before you unwrap the hot pressed hash, as it might crumble apart if not cooled.

I've tried it this way before and it works as well. Hopefully this helps.

[ToDrunkToFish]

Damn thanks no chowder! Though since knowone answered sooner I did it my own way.

We have a brick fire place and I rolled it in a baggy and rolled it a few times. Since some of the close bricks became quite hot I closed the firepit door and set the bag on a little peice of paper under it on the brick.

Then I hammered the shit outa it again. And let it sit there a while and did it once more and since it litterally feels -20 degrees here in Michigan I let it sit outside for 2-3 minutes.

Its not the biggest thing in the world but it did the job. Didnt break apart or nothin. Thanks No-Chowd!

[Nochowderforyou]

Good to hear things worked out for you.