My favorite cloning method... you need:
HEALTHY mothers that have been deprived of nitrogen for the previous week.
-Water them well
-Spray them with WiltPruf, Anti-Wilt, or a leaf shine anti-transpirant spray. Let dry.

Your MEDIA:
Rapid rooter bark grow plugs. Peat pellets are NOT a substitute as they have shitty pH.

Your clones new HOME:
-A propagation tray with a 6-8 inch high dome over it, or a clear plastic box... they need about 8" of space to avoid touching the roof of the dome and rotting.
-under this tray there is a HEAT MAT.. US $25 at a garden store. Worth every penny.
-Lit by FLOURESCENT LIGHTS

Then your TOOLS:
-A NEW UNUSED RAZOR BLADE.
-a small container to pour CLONEX GEL into. Do not dip into the bottle, it will get contaminated.
-A SPRAY BOTTLE of plain city tap water.

-Cut off a growing tip that is at least 4-5" long and has the tip with new leaves, plus at least a pair of nodes lower down the stem.
-Take your razor and slice the lower leaves off carefully.
-Now cut the end of the stem diagonally and dip it immediately into the clonex.
-Let sit for 30 seconds in Clonex, covering the nodes where you cut off a pair of leaves.
-Now stick it into the hole in the rapid rooter.
-Make sure that the nodes that you cut hte leaves off are covered. This is the first site of root growth as there are more undifferentiated cells in this region.
-Make as many clones as you like and make sure they are not crowding each other in the tray.
-Mist them again with Wilt-Pruf.
-Pour a little water in the outer tray so that there is a source of humidity under the dome.
-Put the dome on and place the whol ething on the heat mat about 10-12" from a pair of 40w tube flouros.
-Lift the lid morning and night and mist. They need moisture and fresh air.
-Enjoy! Should take less than 10 days.