Although not completed this is my basic beginner set. Still havent got the mylar up but thats next (sheesh there is a lot more to this than origionally planned) any way you were asking about how I am doing a self contained hydro drip system in one container well this is it.

On the left side of the res is where the water is pumped out of the res into the pipe system I made, the nutes will flow back into the res in the tube you see in the front. On the right side of the res I have a drain valve thats capped off but when opened will empty into the res sitting on the right. To empty the res take note of the shut off valve located on the left side of the feed system. I will use a hole punch to place the drippers accordingly. Then I put a pic of the nutes and other supplies I am using. Also take note of the inline probe casings I built for the two probes of my hanna meter that will be displyed 24/7.

Underneath the res this is what it looks like. I have a 200 GPH pump from the out of the pump I have a 4" hose that feeds into the in of a T connector. One side of the T feeds the main system then the other side of the T I have another T connected to it which leaves 2 more outs and those 2 outs feed up into the probes for my meter analysis.

Tell me what you think LW and others too

Merry Xmas Folks!