How do you I clean up my bong?

[Kushh]

Besides using bong cleaner solutions is there another way to clean the sticky resin from my bong?

Kushh Reviewed by Kushh on 12-17-2006. How do you I clean up my bong? Besides using bong cleaner solutions is there another way to clean the sticky resin from my bong? Rating: 5

[five0addict]

ive used alcohol and rock salt, carb cleaner, acetone. use iso alcohol

[the yeag]

i clean my smoking devices every week. Bubblers bongs and water pipes should be cleaned after each use....just use dishsoap and hotwater dude

[Tokudai]

If its glass, use denatured alcohol salt and hot water. If its acrylic, Id soak it in hot water and use Oxyclean or something. See if you can find a brush like a toilet brush or something that will fit down the neck and it'll make life a lot easier

[Frivolous248]

http://youtube.com/watch?v=LwmVgdEbHUM

[secretgarden]

i used hot hot water with a tooth brush until i found a cleaner designed for removing resin.
I would take the bong apart soak the smaller pieces in hot water while i ran the bong itself through hot water while i scrubbed the inside with hot water. rinse and repeat as required. then i would take the smaller pieces out from soaking and scrub them the same way. just remember to keep the water running it helps to keep the resin from sticking to the sink. fyi use gloves if you can. keeps the smell off your fingers.

[RIP ODB]

I don't know how well any of these other methods work but I can tell you that Oxi Clean works amazingly well. Just plug the downstem with wadded up paper towel or something, fill the bong up to the brim with hot water and drop in a scoop of oxi clean. Wait a little while. If you have a clear bong you can actually see the oxi clean fighting the resin. After this is over, rinse the bong out several times with warm water.

PS - Be careful of drastic temperature changes of your bong, as this can cause it to crack.

[pixel]

RUBBING ALCOHOL + SALT, plug both holes, shake that shit up, let it sit, you're good