Using Super Natrual blooming nutes. Been using half reverse osmosis water, half tap water which results in a PPM of 250. I have gotten my babies up to 1050 PPM (just now seven weeks into 12.12) I am using MOAB at the end of the cycle, you use it for the last two weeks of flowering and you cut down on regular blooming nutes. I was under the impression that the MOAB would not show up on a PPM meter, and the instructions say to cut down by as much as 50% on the regular blooming nutes when adding the full reccomended dose of MOAB. I added 75% of the reccomended dose of MOAB, and then measured the PPM, and it had increased 160PPM - I thought it wouldn't show up? My plan was to give the plants 75% of the reccomended MOAB dose, and then give them 75% of what I usually gave them for blooming. However, I only brought my PPM up to 850 after blooming nutes were added, so I gave them 400PPM of the bloom which is half of what I generally give them. Why did the MOAB show up, and next time I fill my resi should I just bring the water to 1050PPM as that's what they are used to? I didn't want to cut their blooming nutes down by 50%. Any experiences are appreciated, I kind of feel like I am short changing my plants cutting down 50% on bloom especially when I didn't even use the full dose of MOAB.