making a pipe

[slipknotpsycho]

oh yeah here's an idea it was my first pipe and it worked just wonderful. take a hulla hoop and you use a lighter and about every inch or so heat it up til it can be bent (right before it starts actually melting) and what you're going to do is a series of this about an inch apart the whole length of the tube, putting it in a pan or pot of water after every heating and straightening....by the end you will have a semi straight tube...doesn't have to be perfect just kinda matter of opinion....now you make a bowl (i took a square peice of a coke can about 1 x 1 inch and formed it into a bowl by making a cone shape and kind of molding it from there then poked holes with a tack) and there you have it a nice sturdy pipe.....i used that for about the first three years of my pot life.

slipknotpsycho Reviewed by slipknotpsycho on 11-12-2004. making a pipe my friend has a pipe made from home depot supplies how do i go about making one of these ? thnkyou Rating: 5

[Chongzbongz]

nice one slip sounds cool did you cut it to be smaller or what???

[Chongzbongz]

i just got back from the hardware store about an hour ago and bought some steel piping, heres what i just did i cut the piece of steel pipe on an angle at about an inch and a half from the end and took that piece and turned it around and taped it all up.. dropped a screen in and have smoked about a gram so far.... pics of my first harvest on the way so keep watch

[Chongzbongz]

wow... lol i just made another one out of a coke can works pretty good too.. all i did was squeezed the can co it was down in the middle and took a safety pin and poked in some holes...lol

[slipknotpsycho]

yea i cut it to about a foot to a foot and a half.

[slipknotpsycho]

oh yea for got one thing about two inches from one side or another you have to bend it an at an angle (where you put the bowl on it's kinda shapped like a j (not joint the letter j lol)

[Chongzbongz]

lol.... got ya