Need idea for a fix on glass bong

[Nugget73]

so the neck where the slide goes in is a seperate piece from the bottom bubble. It is held in by a rubber seal, yet the seal is getting old and isn't air tight anymore. Anyone think Krazy Glue would work fine if I just glued the neck and rubber seal to the bubble? I know Krazy Glue holds glass and rubber so it should make a tight seal. Anyone know if the heat from the bowl would effect the glue at all? Or is there a better glue to use?

Nugget73 Reviewed by Nugget73 on 11-12-2006. Need idea for a fix on glass bong so the neck where the slide goes in is a seperate piece from the bottom bubble. It is held in by a rubber seal, yet the seal is getting old and isn't air tight anymore. Anyone think Krazy Glue would work fine if I just glued the neck and rubber seal to the bubble? I know Krazy Glue holds glass and rubber so it should make a tight seal. Anyone know if the heat from the bowl would effect the glue at all? Or is there a better glue to use? Rating: 5

[Pshamous]

dude use some of the stuff you use to repair fish tanks get it at like a petsmart dont go to petco, there bastards.

[sensistar]

dont use super glue it turns white on glass....

yo can use hot glue.....they sell hot glue guns with glue sticks fro a dollar at a dollar store --or cheap store...

use a ice cube to form it and set it faster ....if you get your finger wet you can press the glue the way you want it ,without the glue sticking to you ...
you'll get it it works great ,and easy