Hard to explain but ill try...

We wired up our cfls on a board using SIMPLE light :fixtures: (not sure if that would be the right word receptacles maybe....). The 2 outer light fixtures had prongs on one end-that you can plug an extension cord into- and on the other the female end-to screw a light bulb into.

in addition to those two fixtures, we found one that had two slots where you could plug things infor the center light.

Drill holes in your board and fit your fixtures in there. Make sure they wont fall out/through.

We wired up the two outer cfls to the inner fixture (the one that could plug two things into it) by cutting extension cords so that you have the male ends plugging into the middle fixture and the end that we cut wrapped [the wires]around the corresponding prongs on the outer light fixtures. We used liquid electrical tape to seal everything up...

http://i46.photobucket.com/albums/f1...nan/setup1.jpg

We also have two cfls clipped on using standard work lamps.

Sorry if it didnt make sense...