homemade cloner 2nd try

[busteruk7]

ello all well i thought i would make another clonening machine
the first one i made dident do much so i ditched it
i had the idea when i saw this polystyrene box that one of my big fish came in from petshop lurking in the cupbaord
so i cut holes in it for the cuttings to go i need to paint it or cover it with something to keep it dark in there
im gonna use a submersible water pump and some tubing and jets that will attach to the pump and have that set with a timer
i need to get some lava rocks to fill the baskets with
and then im set to go
ill post pictures for ya all to see
and any advice or improvements you think might be helpfull
will be muchly apreciated
cheers all

busteruk7 Reviewed by busteruk7 on 10-24-2006. homemade cloner 2nd try ello all well i thought i would make another clonening machine the first one i made dident do much so i ditched it i had the idea when i saw this polystyrene box that one of my big fish came in from petshop lurking in the cupbaord so i cut holes in it for the cuttings to go i need to paint it or cover it with something to keep it dark in there im gonna use a submersible water pump and some tubing and jets that will attach to the pump and have that set with a timer i need to get some Rating: 5

[emmpey]

Don't wanna piss on your bonfire and all that but check out the 'wick cloner' - simple, cheap and ridiculous success rate for clones.

http://icmag.com/ic/showthread.php?t=10225

[busteruk7]

ive nearly finished my cloner and will take pics after this joint lol
ill give you a full report on how i did it 2
see ya in a bit
cheers all

[busteruk7]

ello all well i think its nearly done
all i need to get now is some hyroponic pebles ,rockwool and cuttings
and the sides of this need covering with sommat maybe ill get some of that black and white sheet stuff
well heres how i made it

to start off i got this polystyrene box ,i took a hole drill and cut the basket holes in the lid, then covered the whole lid in mylar and fitted the baskets,then i got this pump that came off a pc water cooling system,
i had a bit of diffulty attaching the pump tube to the little tubes that run on top of the lid
and had this thought while looking for something
it was a screw on applicator for a tube of bathroom silicon, i cut it a bit and it does the job nicely
the tubes and drippers that run across the top of the lid do the job nicely
,i got them off my m8 legalizedahurb cheers m8
i cut holes for 9 cuttings in the lid, but am only going to do 6 this time to see how it goes
ill let ya know im gonna get the rest of the bits tomorrow and finish it off
so i will probally get ot fired up tomoz night lol
ill upload pics
cheers all

[busteruk7]

more pics
cheers all

[Legalizdahurb]

Looks good bud, I hope it works for you.

[Abattoir Dream]

nice job man

[smokinbomb]

that looks good let us know how it works

-Bomb