How do i make a homemade bubbler?

[mowie wowie]

like out of a gatorade bottle and soda can and shit? help is much appreciated.

mowie wowie Reviewed by mowie wowie on 10-08-2006. How do i make a homemade bubbler? like out of a gatorade bottle and soda can and shit? help is much appreciated. Rating: 5

[slpntrx5]

its more of a bong, but i'll give you instructions in a sec. i have to go eat din din really quick.

[nevaquit01]

See my post under this. The Wal Mart Bong.

[slpntrx5]

alright what you do for the bong is:

1. take a plastic bottle and fill it abotu 1/4 to 1/3 up with water (don't use glass, as you have to use a special drill bit to make the carb/slide hole)

2. mark the water line on the outside using a sharpie or other marker (or just eyeball it)

3. take a bic pen and stab a hole about 1/2 in. (1 cm or so) above the mark

4. hold the bottle like you're going to be holding it when you take a hit and make another hole where your thumb is (this is the carb)

5. take apart the pen and discard everything except the "body" of the pen (the little plastic tube that houses all the insides)

6. stick the tube into the lower hole and tape up the hole afterwards, if need be

7. take a piece of tin foil that's about a 3 in. (8 cm or so) square and wrap it around your index finger

8. now put your finger in the foil roll until the first section of it is completely covered, then take the ink cartdrige of the pen (the tiny plastic tube that has the black/red/blue junk in it) and slide it into the foil roll until you can feel it against your finger, then with your other hand, squeeze the foil around the cartdrige. the result should look a little like this:

l_l <<< this is where your finger was
l
l <<< this is where the cartdrige was

9. put the foil bowl into the pen tube that's stuck in the bottle

10. assuming you already know how to use the carb and such, load it up, spark it, and ENJOY!!