Building Your Own Bong

First off you need a pen that you can take the inerds out of easily, a milk jug of plastic bottle, a good sharp knife, and some aluminum foil or something else to make a bowl out of, and some duct tape or medical take.

1)Take the inerds out of the pen

2)Use aluminum foil to make a bowl (whatever size you want it) tape it on good with the tape

3)Cut a small hole near the bottom of the bottle and insert the pen so that is is at an angle and touches the bottom

4)apply tape liberaly to make a good seal

5)Make a choke if you like

6)Pour water into the bottle to just about 1-1 1/2 inch below the bowl

7)Pack the Bowl

8)Suck out of the mouth of the bottle and light the bowl

9)When the bottle is full of smoke ( i mean so dense you cant see through it if you tried) release the choke and suck it in deep

10)Congrats you've just built and smoked your own bong

NEXT

1)Ok first drill a hole in 1 butt cap just barely big enough for the male side of the brass fiting to fit into then screw on the thread to non-thread adapter epoxy the bowl side to ensure air tightness

2)Cut off about 2 inches of the 2 inch pvc and put the butt cap on it

3)while the epoxy dries ( this should take from 10 minutes to and hour depending on the brand) cut off anothe 2 inch peace of the 2 inch pvc and put the second butt cap on it, then take the y fiting and with 2 openings facing the ceiling put the one that faces the floor on the other side on the 2 inch peace

4)after the epoxy dries cut a peace of the 1/2 inch pvc just long enough to reach from the adaptor to about the middle of the y fiting from the 45 degree side

5)put the elbow on facing downward and cut anothe peace to reach about 1/2-1 inch from the bottom

6)now take the rest on the 2 inch pvc and cut the main tube as long as you wish (mine stands at about 3 feet total)

7)inset into the straight up hole on the y fitting

8)put the cupling on as a mouth peace

9)drill a hole about 3 inches from the y fiting as a choke

10)smoke that puppy

This pipe can be made preety much any size with a few modifications, i have an 8 inch wide one that is about 10 feet long, just added a couple of reducers to make the mouth peace right

Rev. Michael T
Soldier for Christ and Cannabis