OK, Take the black glass part of the bottom of the light bulb out. I use scissors and push through on it, and then after it breaks I twist the scissors so all the glass breaks. Next, get all the stuff inside of the light bulb out, just pull it out. Then get some salt and pour it in the lightbulb (to get the white stuff off of the inside lining) put your hand over the open end to shut it, and then shake it all around. You'll notice that the salt takes the lining right off. Then get a bottle cap put a hole in the middle of it (the size of a pentube, iwould just make a small hole and push an empty pen tube through it. Noe make a smaller hole next to it, this will act as a choke/carb. Now get a lot of tape (electrical is what i use) and tape the ca to bottome of the lightbulb so that its air tight, just test it. Now i take the pen tube out and drop the weed through that hole. Then just light it w/ whatever you got lighter/or candle. There ya go, O ya onem ore thing i would wash the lightbulb out after your done w/ the salt and let it dry.:rasta: