Hello Haris7,


I was looking at the nice pic you posted of your closet...

Very nice. Watch for it, because you'll see it get transformed into something very special.

I think you should monitor your temperatures in your "lower" chamber, where the ballast is located. Make sure the temperatures don't climb too high ().

Another thing, is that I see the rug, as a floor.
Carefull... from my experience, you'll get lots of water on the floor. Water with nutrients. Constantly. Plus all the dirt that flies away. And the leaves that will fall off. etc.

So, maybe you want to put something down there to protect the rug (if it matters).

IMO, the fluorescent setup you've got on the floor right now, if all four bulbs are turned ON, it's too much for cloning. When you're off to do it, start off with one bulb, maybe two. Too much light can stun the clones.

The other thing is light proofing.... you should take small steps constantly to keep on light proofing your cab. When 12/12 comes around, you want that completely dark. Especially if you're running a veg schedule down at the bottom.

I liked to use the 'black pond liner' material they sell at hardware stores. Drape it over the seams and hold it down.


Nothing... looks good budy!



-turtle
turtle420 Reviewed by turtle420 on . My kick ass grow room Hey this is the grow closet me and a buddy built today. I think it's pretty sweet. Under the big chamber is a little area for cloning, the ballasts, and some storage. Once the plants are ready to flower I plan to build a wall between the two lights so i have a flower chamber and a vegging chamber. I've got a room (2ft x 7ft x 8ft) with: 400W MH (on the right) 400W HPS (left) 100W T5 Florescent under for cloning lovin it, best grow room I could hope for only problem is my Rating: 5