I'd be shocked to find if others have not already thought of this on their own as well, but just in case you haven't heard about it, this is one of the most intense (if somewhat incestuous), yet smooth smoking methods.

Roll up a fatty, hit it a few times to get it firing on all cylinders (if you bong it too fresh the powerful b-suction will just run the paper), then "screw in" the end of your joint into the throat of your bowl. You don't have to get it in there too deep really, the suction of the bong will seat it down nicely.

You get all the advantages of a bong (enormous hits cold filtered through ice water), but only have to light it once (stays lit longer than a bowl). Plus, since a joint is a little self-resinating stick, by the time you get to the bottom, your number of hits per unit j-length increases.

The Boint. Best of both worlds.


*Blung variation: Instead of inserting the j into the hole of your bong's BOWL, remove the bowl entirely and either put a two paper j (or a BLUNT if you've got big brass swingers) directly into the opening of the wider shaft. I personally don't prefer this method though, because you have to pull the joint or blunt out of the shaft to clear a hit instead of pulling the bowl, but just thought I'd throw that out there too.

Consider the 2600 to be officially reactivated, after about a good (bad) clean year without. Re-introduced myself in the local Texas subforum, but am just making my first lounge appearance.
2600 Reviewed by 2600 on . Anyone smoke Boints and Blungs? I'd be shocked to find if others have not already thought of this on their own as well, but just in case you haven't heard about it, this is one of the most intense (if somewhat incestuous), yet smooth smoking methods. Roll up a fatty, hit it a few times to get it firing on all cylinders (if you bong it too fresh the powerful b-suction will just run the paper), then "screw in" the end of your joint into the throat of your bowl. You don't have to get it in there too deep really, the suction Rating: 5