Sounds like you really know what you're taking about invision. What I'm tkinking is drilling like three or four big ole holes(1/2' diam. or so) on a side wall, bottom front, and then putting the fan at the top back wall, opposite side from the holes, blowing out. Sort of pulling through fresh air. Remember this is a small box. What do you think?
qdavid Reviewed by qdavid on . Fan installation? I built a small grow box but completely forgot about venting. I was considering just using a desk fan and leaving a door open but that'd probably screw the flowering phase, in a couple months. From reading and replies, I gather putting in a computer fan is my best bet. My question lies in powering the sucker. I have a bunch of power transformers I've gathered over the years, but all the fan advertisements say 3 or 4 pin. I don't know if I could wire one up right. Is there an easy way? Any Rating: 5