Here is another, more revealing picture of it. The paper I used was ZigZag Lights, 1 1/4 pre-gummed. I used an index card cut to the same height as the filter I pulled out, and rolled up tight for the roach. I wet the very end REALLY wet, and twisted it up tight, then let it dry, and snipped off the twist.

You can see where my paper and the filter overlap, and where I used a cut off, gummed up, strip to seal and secure the filter paper to the zigzag paper. I'm working on overlapping the two less and less to expose more of the filter paper and make it look better, but it gets tough to hold onto everything and roll it up tight.

[attachment=o80636]
Sig Reviewed by Sig on . The Secret Agent (pic) I've been working on my "secret agent" joint lately and thought I'd share. My first couple of joints I used the butt of some marlboro lights that were white and had two gold rings. For this one I used the butt of a camel light. I did this because I wanted the end to be orange so it looked more like a cig. I didn't have enough pot to make a full length joint, so this is a mini-me secret agent. Here's a pic of mine. Here are the directions: Joint-smoking often demands a little Rating: 5