So as you can see I have the bottom 3rdish of the cabinet for the main growing chamber. Its gonna be a scrog setup and the light can go up another 10 inches so it should be a good fit. Not sure if im gonna go with 4 or 6 plants yet, but I think im leaning towards 4. If it matters its an aero-machine type system with a 400watt HPS lamp. I imagine i'll use the middle for all the electronical connections as well as supplies. The top I am hoping to use for a cloning chamber, but I dont think its gonna be big enough to veg em until the flowering plants are out...

Anyway the whole point of this is I want to know what you guys think the best way to setup the vent system since its a 3 section cabinet. I think a cooltube type deal is a given, but im not sure how to route the rest (please be sure to note there will be a carbon scrubber used on the exhaust!).

Also im wondering what the best way to drain the res on this setup is gonna be since the plants will be tied into a screen... is my best bet to use a cheap inline pump to pump fluid out into a bucket (and vice versa to fill it)?
ugexe Reviewed by ugexe on . Picture of my cabinet so far... now how to handle air flow? So as you can see I have the bottom 3rdish of the cabinet for the main growing chamber. Its gonna be a scrog setup and the light can go up another 10 inches so it should be a good fit. Not sure if im gonna go with 4 or 6 plants yet, but I think im leaning towards 4. If it matters its an aero-machine type system with a 400watt HPS lamp. I imagine i'll use the middle for all the electronical connections as well as supplies. The top I am hoping to use for a cloning chamber, but I dont think its Rating: 5