Some stupid PPM questions

[dingobaby]

Zandor, I got confused on your post earlier when you were talking about the PH.

You said "Now that you have the Ph set you can add the CalMag Plus (if you are using RO water) Also you can start adding what other enhancers you are going to use."

I'm all confused about PH, from my understanding you check the PH after you mix the nutes, am I right? Why would you have your PH set, and then add the Calmag and other enhancers after you have a set PH? Would the cal-mag and other enhancers not lower or raise the PH?

Confusing or not, you da man-

[Zandor]

Zandor, I got confused on your post earlier when you were talking about the PH.

You said "Now that you have the Ph set you can add the CalMag Plus (if you are using RO water) Also you can start adding what other enhancers you are going to use."

I'm all confused about PH, from my understanding you check the PH after you mix the nutes, am I right? Why would you have your PH set, and then add the Calmag and other enhancers after you have a set PH? Would the cal-mag and other enhancers not lower or raise the PH?

Confusing or not, you da man-

You check before, during and after.

Before is your control number so you know where you started. Most modern nutrients on the market today for this plant have buffers in their mixture. If you pre Ph then mix your nutrients they will hold the Ph better and closer to the number you want.

CalMag Plus is what you use to replace nutrients the RO process takes out but the plant still needs.

Not all nutrients play well with each other, some of them duplicate each other but with cleaver marketing you never know unless you understand the label and what they put in to make the formula.

Enhancers are just that.....they enhance the base NPK nutrient. They are not meant to replace a good quality full NPK nutrient mix. You may need to tweak your NPK so you don't over feed your plants. That depends on the life cycle the plants are in as well.

I hope that helped you.

[Zandor]

zandor i have to harvest ?
my plants are ready and i flushed with clear x and pure water
but ppm is still 1500 - can i harvest or do i need to get the ppm lower

Check the starting PPM and the ending PPM if there is less then 50 points difference or less then they are leached properly and ready for harvest.

[BOYZNUS]

SORRY TO INTERUPT THIS THREAD.

Opie Yutts,,, PLEASE USE THE WHITE CURTACY PHONE TO CONTACT ME.

I HAVE COMMENTS ON YOUR "NO PEST STRIPS".

I NEED THE WORLD TO KNOW THE GREATNESS OF THESE.

BOYZNUS AT YAHOO. COM

YOU ARE NOW MY MENTOR.