How to Roll?

[Ms Almenjoi]

ummm im a shitty roller....is there a technique i can use or somethin cuz wen i roll my blunt always tear up or it will be to skinny...do i breakdown to much or wat?? pleaz help

Ms Almenjoi Reviewed by Ms Almenjoi on 06-02-2006. How to Roll? ummm im a shitty roller....is there a technique i can use or somethin cuz wen i roll my blunt always tear up or it will be to skinny...do i breakdown to much or wat?? pleaz help Rating: 5

[ChronicMike]

I always use a razor, gets a perfect cut everytime.

but if your 18 and have access to a smoke shop then buy a blunt splitter, its probley the best smoking invention ever...just a small plastic tube that you slide through and cuts the blunt perfect.

also heres some tips- go to www.concept420.com and check out the how to section about joint/blunt rolling, i hoped that helped

[Solistus]

It depends largely on what kind of cigar you're using, but general tips:

-Be sure to get the leaf (or both leaves if applicable) very moist; dry leaves tend to break very easily.

-Remove any stems from the ground bud. Sometimes, a tiny bit of stem that was attached to a bud will come out of the grinder sharp. These little things love to tear your paper/leaf.

-If it's too skinny, add more pot! There's no other (good) way to make a blunt fatter, except perhaps making it shorter.

When are you tearing them? I could give you specific pointers about splitting the leaf, rolling the inner leaf, or whatever else is giving you trouble.

[smokin dope]

well for joints, my technique is grab a paper, toss in soem fire, and line the paper up to the other side of it, and roll the two sides of paper in between your fingers, youll get the hang of it, but roll that nice and tight but not too extreme, then roll/fold over, lick and i usually do a nice lttle twirl in my fingers to make it nice and perfect.

for blunts, grab a phillie, swisher, or any form of blunt, lick that hoe up nice, but not too wet, either use your finger nail/thumb nail or a blade, knife, something sharp and split her open. grab your bud, throw it in, this is a little diff then a joint, but what i do is lightly start rolling one half in the joint technique, pushing down any weed that tryes to get out the top, lick and seal, and then i usaully give it a good lick, and slowly light the entire blunt to dry it out a little, or another good one is put it in a microwave for about 10 seconds, but watch it, dont go over 10, and that seals it up amazingly/.

if you read this, try it out, im glad i could help, i love rollin

[Ms Almenjoi]

well i usally use swisher sweets or i would u blunt paper......well i jus go down the cig and pull it apart..its an ugly tear and the leaf starts to break off....and wen i use a razor it does the same thing...its like i start to cut it ..i go down den the razor gets stuck..den i start from the top again...until im finish...and i dont use a grinder i jus breakdown with my fingers....and another thing ive been told the steams are the best

[spliffstar22]

You gotta take time with it. It takes practice. Your not gonna just pick it up in a day. I remember my blunts were decent, but not that tight, nice long smoking blunts. Now I crack and roll a blunt in like 2min flat. just go down with the razor quick and easy. Don't go slow, go fast with it, than roll. Or just grab a blunt wrap if you don't wanna try that....

[Solistus]

I recommend trying a Dutchmaster (honey if you can find it). I have much better luck with dutches than swishers, typically. I tend to avoid phillies; they burn too fast.

[KillerDemo]

also make sure the dank is broken up very fine because its hard to roll when there are big pieces.

[orangeman]

ummm im a shitty roller....is there a technique i can use or somethin cuz wen i roll my blunt always tear up or it will be to skinny...do i breakdown to much or wat?? pleaz help

Well first off you arent suppose to break every nug down completely until it's sawdust when your rollin a blunt. You break it down half way, leave the buds to be just a bit small, probably the size of this O and dont try to roll the whole blunt in one time..you have to roll one side first, lick it down so it'll stick and tuck the other side and roll it upwards and stick that part also and you've got your blunt .

[notech]

Well.. Plenty of good tips from helpful members there. . . .
Always remember that practice makes perfect. . . .
And best of luck with future rolling. . . . :thumbsup: