Quote Originally Posted by kush07
If you are still in school then all the materials you need are right at your fingertips. Of course, you will have to pilfer them.

To make a good homemade bong get a fairly large graduated cylinder from your chem or physics classrooom. If they have water filters with little holes in them get one as well. You will need a power drill, a .25'' drill bit, electrical tape, and some super glue if you managed to get a filter. Go home with your newly acquired materials and get cracking with some tunes.

Instructions (if you had a filter for ice catching):
1. IF you managed to procure a filter, cut the cylinder at its halfway point. Do your best to keep the line straight
2. Take your drill and drill bits and make a hole at roughly 3''-4'' above the base.
3. Take your electrical tape and go around your cut marks and the rim of the cylinder to smooth things out.
4. apply super glue to tap on top half of bong and let it sit on top of the cylinder
5. repeat step4 but in this case it will be the base
**Make sure you let the glue sit for at least 20-30mins to ensure dryness
6. let bong sit our overnight to let fumes go away.

(if you did not get a filter just do step 2 and put your electrical tape around the rim so that it will be soft when you take a hit and not scratchy and rough)

Now you need a slide for your bong. this can be a little tricky to make a ghetto slide but it is doable. You will need a pen completely stripped out, alluminum foil, and a rubber band. First take a small strip of alluminum foil and wrap it around the base of the pen and make sure it is somewhat tight. Now take some more foil and put it near the end of the pen where you applied the other alluminum foil. Shape the foil into the shape of a bowl. You may need more foil to get the desired shape. Once you have your desired shape take your rubber band and cut it. Tie the band around the foil till all foil is secure. Put one end of the band beneath the other to ensure its secure. Now roll ball of foil and put it in the hole at the tip of the pin where the bowl is. Make sure the ball is big enough to fit in the hole but not too big so that all air is blocked. Now you have a ghetto slide that functions pretty well.

Now, you could always make a apple bowl. Those are pretty simple and have a good after taste. Just get a good ripe apple and cut the top till it is in the shap of a funnel. Be careful to stop before you reach the seeds or you willl have to take them out. Get a pen or other small puncturing device and make two holes on opposite sides of the apple with both leading in to the cut out. These will function as the carb and the mouth opening. Once you have the funnel shape get some alluminum foil and place it all around the top of your apple with some dipping in the funnel. Press down on the center of the foil till it dips into your apple. It is best to do the next step with safety pins or clothes pins but a knife will suffice. Cut holes into the foil at the place you will place your erb (if it is a knife one small cut will do). If you have spare safety pins put them into the foil so that it will not slip in case of accidenal touching. Add ganga and fire and you have a homemade apple bowl.
**I have heard the same can be done with oranges but have as of yet to try it.

Sorry if it was a long read but I made it as short as I could.

Happy Toking :rasta:

PLEASE dont use alum foil
just glue a socket from a wrench set to the end of the pen
da haze meister Reviewed by da haze meister on . ghetto pipes/bongs plz help Ok, because i suck at rolling joints/blunts and dont got any bongs or bowls i need to make ghetto ones:rasta: can anyone help me out on how to make one. I saw a few instruction on it but i need to make one without using a BOWL. also i heard that smoking out of aluminum foil is bad for you, is it bad if you just use it ones? Rating: 5