ghetto pipes/bongs plz help

[Drolover]

Ok, because i suck at rolling joints/blunts and dont got any bongs or bowls i need to make ghetto ones:rasta: can anyone help me out on how to make one. I saw a few instruction on it but i need to make one without using a BOWL.

also i heard that smoking out of aluminum foil is bad for you, is it bad if you just use it ones?

Drolover Reviewed by Drolover on 05-12-2006. ghetto pipes/bongs plz help Ok, because i suck at rolling joints/blunts and dont got any bongs or bowls i need to make ghetto ones:rasta: can anyone help me out on how to make one. I saw a few instruction on it but i need to make one without using a BOWL. also i heard that smoking out of aluminum foil is bad for you, is it bad if you just use it ones? Rating: 5

[kush07]

If you are still in school then all the materials you need are right at your fingertips. Of course, you will have to pilfer them.

To make a good homemade bong get a fairly large graduated cylinder from your chem or physics classrooom. If they have water filters with little holes in them get one as well. You will need a power drill, a .25'' drill bit, electrical tape, and some super glue if you managed to get a filter. Go home with your newly acquired materials and get cracking with some tunes.

Instructions (if you had a filter for ice catching):
1. IF you managed to procure a filter, cut the cylinder at its halfway point. Do your best to keep the line straight
2. Take your drill and drill bits and make a hole at roughly 3''-4'' above the base.
3. Take your electrical tape and go around your cut marks and the rim of the cylinder to smooth things out.
4. apply super glue to tap on top half of bong and let it sit on top of the cylinder
5. repeat step4 but in this case it will be the base
**Make sure you let the glue sit for at least 20-30mins to ensure dryness
6. let bong sit our overnight to let fumes go away.

(if you did not get a filter just do step 2 and put your electrical tape around the rim so that it will be soft when you take a hit and not scratchy and rough)

Now you need a slide for your bong. this can be a little tricky to make a ghetto slide but it is doable. You will need a pen completely stripped out, alluminum foil, and a rubber band. First take a small strip of alluminum foil and wrap it around the base of the pen and make sure it is somewhat tight. Now take some more foil and put it near the end of the pen where you applied the other alluminum foil. Shape the foil into the shape of a bowl. You may need more foil to get the desired shape. Once you have your desired shape take your rubber band and cut it. Tie the band around the foil till all foil is secure. Put one end of the band beneath the other to ensure its secure. Now roll ball of foil and put it in the hole at the tip of the pin where the bowl is. Make sure the ball is big enough to fit in the hole but not too big so that all air is blocked. Now you have a ghetto slide that functions pretty well.

Now, you could always make a apple bowl. Those are pretty simple and have a good after taste. Just get a good ripe apple and cut the top till it is in the shap of a funnel. Be careful to stop before you reach the seeds or you willl have to take them out. Get a pen or other small puncturing device and make two holes on opposite sides of the apple with both leading in to the cut out. These will function as the carb and the mouth opening. Once you have the funnel shape get some alluminum foil and place it all around the top of your apple with some dipping in the funnel. Press down on the center of the foil till it dips into your apple. It is best to do the next step with safety pins or clothes pins but a knife will suffice. Cut holes into the foil at the place you will place your erb (if it is a knife one small cut will do). If you have spare safety pins put them into the foil so that it will not slip in case of accidenal touching. Add ganga and fire and you have a homemade apple bowl.
**I have heard the same can be done with oranges but have as of yet to try it.

Sorry if it was a long read but I made it as short as I could.

Happy Toking :rasta:

[Drolover]

tnx for the help I think i will make a apple bowl.

[da haze meister]

If you are still in school then all the materials you need are right at your fingertips. Of course, you will have to pilfer them.

To make a good homemade bong get a fairly large graduated cylinder from your chem or physics classrooom. If they have water filters with little holes in them get one as well. You will need a power drill, a .25'' drill bit, electrical tape, and some super glue if you managed to get a filter. Go home with your newly acquired materials and get cracking with some tunes.

Instructions (if you had a filter for ice catching):
1. IF you managed to procure a filter, cut the cylinder at its halfway point. Do your best to keep the line straight
2. Take your drill and drill bits and make a hole at roughly 3''-4'' above the base.
3. Take your electrical tape and go around your cut marks and the rim of the cylinder to smooth things out.
4. apply super glue to tap on top half of bong and let it sit on top of the cylinder
5. repeat step4 but in this case it will be the base
**Make sure you let the glue sit for at least 20-30mins to ensure dryness
6. let bong sit our overnight to let fumes go away.

(if you did not get a filter just do step 2 and put your electrical tape around the rim so that it will be soft when you take a hit and not scratchy and rough)

Now you need a slide for your bong. this can be a little tricky to make a ghetto slide but it is doable. You will need a pen completely stripped out, alluminum foil, and a rubber band. First take a small strip of alluminum foil and wrap it around the base of the pen and make sure it is somewhat tight. Now take some more foil and put it near the end of the pen where you applied the other alluminum foil. Shape the foil into the shape of a bowl. You may need more foil to get the desired shape. Once you have your desired shape take your rubber band and cut it. Tie the band around the foil till all foil is secure. Put one end of the band beneath the other to ensure its secure. Now roll ball of foil and put it in the hole at the tip of the pin where the bowl is. Make sure the ball is big enough to fit in the hole but not too big so that all air is blocked. Now you have a ghetto slide that functions pretty well.

Now, you could always make a apple bowl. Those are pretty simple and have a good after taste. Just get a good ripe apple and cut the top till it is in the shap of a funnel. Be careful to stop before you reach the seeds or you willl have to take them out. Get a pen or other small puncturing device and make two holes on opposite sides of the apple with both leading in to the cut out. These will function as the carb and the mouth opening. Once you have the funnel shape get some alluminum foil and place it all around the top of your apple with some dipping in the funnel. Press down on the center of the foil till it dips into your apple. It is best to do the next step with safety pins or clothes pins but a knife will suffice. Cut holes into the foil at the place you will place your erb (if it is a knife one small cut will do). If you have spare safety pins put them into the foil so that it will not slip in case of accidenal touching. Add ganga and fire and you have a homemade apple bowl.
**I have heard the same can be done with oranges but have as of yet to try it.

Sorry if it was a long read but I made it as short as I could.

Happy Toking :rasta:

PLEASE dont use alum foil
just glue a socket from a wrench set to the end of the pen

[lateralus]

Light a cig, burn a hole in the side of a two liter with the cherry (about halfway up), slide an emptied out pen in there (actually, you'll need a couple of them taped/glued together somehow), and attach some sort of metal bowl (not aluminum) to the stem. Then burn another hole a little above where you slid the stem in if you want a carb. The reason I tell you to burn the holes with a cigarette is because when you do, the pen is a *perfect* fit, and will usually be almost completely airtight.

That's basically your traditional 2-liter bong.

[Radio Caca]

I agree with Da Haze Meister. What I did was shove a 1/4 inch socket onto a empty bic pen (fits perfectly but I taped it there anyways). Then I took one of those things that hold tea bags, they're like little pouches with tiny holes all over them, and cut a small circle out of one side. Then I shoved the circle into the socket as hard as I could so that it was basically stuck in there.

Tin foil doesn't even sound like a good idea....

[Cooler Then Jesus]

real ghetto nigs ive met have only smoked Blunts and Gravity bong theit entire life, and that it is in Oakland CA.

so i guess you can call Gravity bongs "ghetto"?

[PSB808]

i broke my pipe couple months ago because i was all irie and forgot my pipe was in my shirt. so i shaked my shirt cause there were ashes on and jus when i lifted my shirt to shake it the pipe fell to the floor and it shattered.

so i found materials around the house to make a new pipe.

Materials
Cable Plugs "the bowl" http://www.m-99.co.uk/Connectors_Par...rs/770_150.jpg
Plactic Tubing (~2 in diameter) http://www.cleanersolutions.org/imag...nitial%202.jpg
Zip Ties (any color) http://i22.ebayimg.com/02/i/04/ff/d3/52_2.JPG
Screen http://www.sinsemillasevilla.com/VAR...AS/pipe_screen

1st Step
Make a slit in the platic tubing so can snug the "the bowl" nice and tight.

2nd Step
Take 2 zip ties and tie down the extra plactic from the tubing around the bottom of the bowl so that its airtight.

3rd Step
Cut the screen so it fits in the bowl. Then push down with a pen or pencil whichever is nearest to you. Suck to see if its airtight (cover the bowl suck and if u cant suck its airtight).

Last n Final Step
Grab some buds, break a piece off and fly it in your bowl. Take your Green Bic and Start Smoking!!!! :rasta:

This is my alternative pipe it works real good and gets me all irie.