pen pipe

[WannaSmokePot]

How do you make a pen pipe? Obviously you dismantle the pen, but what do you use for the bowl? Do you just attach it with tape?

WannaSmokePot Reviewed by WannaSmokePot on 05-10-2006. pen pipe How do you make a pen pipe? Obviously you dismantle the pen, but what do you use for the bowl? Do you just attach it with tape? Rating: 5

[slipknotpsycho]

depends on the pen, some (not the cheap paper mate or bic's) have like this hard-acrylic type plastic body, and a metal tip, all you have to do is 'gut it' turn the tip backwards, and use electrical tape to hold it in place....

[doitbig]

whats up

[willystylle]

I've made a pen pipe using a parker pen.

1. Take the pen part out and drill the bottom of the pen out.
2. Take the lid and drill the top out.
3. Use a pipe-bender to bend the lid 90 degrees.
4. The lid should fit back on the pen backwards, and bend upwards. This is your bowl.
5. Take a piece of wire (I used welding wire) and make a coil just big enough to fit in the lid. This is your sieve.

Really easy to make and I must say having a parker pen-pipe is very james bond.

[RevolverBlaze]

just get one of those metal pens [thicker is always nice] take it apart and just think awhile. I made mine by drilling through the middle, making a metal bowl out of a wing nut I cut up and putting inside. The pen is completely workable, yet all the pieces are inside it so no mess. If I can make a pen pipe stoned, you can do it.