Quote Originally Posted by Pride
Doh... can't I just hammer a tiny nail into it? I just gotta make a really tiny hole. I really don't wanna go out and get power tools for this shit.
you can try, but all you're going to do is break the glass. i drilled a hole in a corona bottle (has thicker than average glass) with a 40 dollar power drill, and a relatively new all purpose bit... didn't need a special bit or anything. anyways, it takes time, i wrapped my bottle up in quite a few layers of tape, then poked a small hole in the top of a water bottle, then i just took a firm grip on the drill, and angled the bottle so all i have to do is press down (it required someone holding it, you have to press relatively hard, or the bit will just skip around the bottle, also because you're not using diamond tipped bits, it is going to take some time, after 5 mins of drill time (not including stopping, to check your progress, add more water or so on) i was about half way through, few more minutes and i was all the way through, then i tried (this was just a tester bottle, to see if i could even do it) to make the hole larger, but ended up breaking the glass cuz i didn't take my time.. hope this helps..