Ok, This works too. Get a 2 liter bottle, about a quarter - 2/3 of the way up the bottle make a hole and put a hollow pen/tube down there [make it permanent if you want] unscrew cap, fill with soem water, put mouthpiece of pipe to the tube and suck through top. I've often broke bong slides and supstituted my pipe as a slide like this [great last minute fix] and it hits damn fine [unless your piece sucks]. But I suggest something more sturdy than a 2 liter, as to they crunch inwards, if you take a lighter to the outside walls and heat them up, they constrict and toughen, thus preventing it from crushing in as much, just dont melt the bottle.
RevolverBlaze Reviewed by RevolverBlaze on . Making bong I have this pipe from CVS, you know the weird tobacco ones, and I just use the one piece, not the stem, I only use the actual bowl part so it hits hard. I usually roll joints but I was wondering if I took that piece from the pipe, attached it to like a 2 liter or some chamber, and with a rush hole, could i get hits still, or would it be too hard to hit, like would I have to breath in much harder and shit. Sorry if this makes no since. Let me know. Oh and I would just open up the top of the Rating: 5