Quote Originally Posted by God v2.0
okay so im kinda confused about how to do this, if i buy a 2 speaker Amp wiring kit will i have everything i need to install it?

Also im guessing that i get some of those a/v cords (i know they arent audio/video but thats the closest kind of connector that i know, and they have the same shape) and run those from the pre-amp outputs coming out the back of my head unit. then just connect the subs to leads and run the leads to the amp right?

its got 2 built in 20a fuses as well, but do i need to put anymore aslo where to i find a +12V power lead, also i know how to ground it, just run a lead to the frame and bolt the bitch on there.

also there are two places to connect the pre-amp outputs one says high-input and one says low-input, the low input is the same conenction as the outputs on my headunit, but what about the high-input, is that for speakers? it has leads coming out of a connector
The connectors are called RCA cables...

install hed unit

run RCA cables to the low input....That means BASS. If you use the high input side. Your amp will have to convert power/signal to just power it was make too much heat.

Yes i would run and inline fuse even if the amp has 2 (cant be too safe)


Ground to frame is best.... if you are mounting it under your seat take a bolt out from your car seat (claen it for good conectivity) and there is your ground.

I would bridge.....it, it in series. it will increase power and not drop ohm load.

Take the positve from from the left and connect it to the negative on the right.
now you have one positive and one negitive and a wire nut holding the other together.

you can just put pos to pos and neg to neg, but it will rop your ohm load to 4.