This is the info we needed

Amplifier features:MOSFET power supply and output devicesStereo or bridged mono outputSelectable bass boost: 0, 8, or 15 dBTri-mode protection4 ohm RMS output: 2x120 continuous watts per channel2 ohm bridged output: 360 wattsVariable 45-300Hz high-pass filter45-300Hz low-pass filterSubwoofer features:Plating injection-molding cone with polypropolene material50oz single-stacked magnet87dB8 ohms/4 ohmsInsulated 20-gauge tinsel leads


I would bridge it in series..... and see if it can handle it.

Make sure you have a good ground....and a inline fuse or circut breaker.

Remember DONOT ground any leads.....

Magnet is a little light.....

single coil....

only 87 db at 1watt at one meter

a cheap series one..... has 91 sensitivity