Tightening a Joint once its been rolled

[Chainsaw1234]

Is there any possible way to tighten joints after they have been rolled?

Chainsaw1234 Reviewed by Chainsaw1234 on 04-20-2006. Tightening a Joint once its been rolled Is there any possible way to tighten joints after they have been rolled? Rating: 5

[Loudogg]

tear em open and re-roll, of just pack more in the end if you can. Give it a little twist can help too.

[LIP]

Roll it inbetween computer paper

[Don Don]

After you first roll the j if its to lose then you could twist it with your lips.(also meakes it burn longer.)

[Chainsaw1234]

erm.. anymore??

[Psycho4Bud]

Twist one end tight, hold the other end and shake it back and forth gently. Then just tare off the excess paper. Works for me at least.

Have a good one!:thumbsup:

[187]

Twist one end tight, hold the other end and shake it back and forth gently. Then just tare off the excess paper. Works for me at least.

Have a good one!:thumbsup:

was just about to say that

[slipknotpsycho]

there's an alternative to this...flatten one side COMPLETELY so all you see is paper, then hitting the 'flat' end over and over relatively hard... it'll pack it down better/evenly... but if you hit the loose end, it'll do just the opposite...

[da5mikeY]

k, lick it a little bit all the way around, not rediculously wet, just to make it moist, and make sure every part of the joint is moist too, then put it in a dollar bill and roll it around...it works 70% of the time, everytime

[sirsmokesalot]

if possible, i do this all the time, just either remove the roach (if you have one) or untist one end. then take a match and pack the weed further down into the already rolled tube. of course this will make it shorter, but i like it as it burns longer and more slowly, doesnt break or bend as easily, and overall feels more sturdy in your hand.