Yo everyone! Im sure uve all herd of a lightbulb vapouriser¿ Well i decided to make one and i suggest everyone out theyr definitly makes one and tries it out!! I simply take a lightbulb and some "pruners" my pruners wher nice they could fit the metla part of the bulb right between its VERY sharp blade! Now i cut the end of the bulb off on the very LAST thread! so farthest u can from the fat part! Now cut it off all the way! leaving u wih a lightbulb with a open end but it will still be full of plastic! take a screwdriver one that will fit into the glasse and simply knock on the bottom of it till it smashes then take a pocket knife and take the remaining glasse out and then if u have those ligtbulbs that are white not see thru take salt and water and take that stuff out! now ur left wiht a nice vapouriser put a pepsi bottles top on the open end and make 2 holes one that a straw will fit in! then simply take ur sweet mj and put it in the bulb and put the bottle cap on the end light under the mj on the other side of the bulb and suck the straw and use the 2nd hole as a carb! i swear i did a few lil bits of weed in this and i was stoned!! Illl post pics in 30 mins after i remake one just for you guys!!
markdahman Reviewed by markdahman on . Let's Vapourize! Yo everyone! Im sure uve all herd of a lightbulb vapouriser¿ Well i decided to make one and i suggest everyone out theyr definitly makes one and tries it out!! I simply take a lightbulb and some "pruners" my pruners wher nice they could fit the metla part of the bulb right between its VERY sharp blade! Now i cut the end of the bulb off on the very LAST thread! so farthest u can from the fat part! Now cut it off all the way! leaving u wih a lightbulb with a open end but it will still be full Rating: 5