Okay, i saw this on some website, but here is genreally how its done

Okay, you take like a thin piece of bamboo, and some pot oil, and start wrapping destemmed leaf strips around it. do that until it is reasonably thick, okay?
then you take some fine ground marijuana, mix some resin into it and paste it on the cigar.
now you take more leaf strips, and pot oil, and continue wrapping. then you take your cigar, and leave it in a dark, humid area for a couple days, and check and see if the stick of bamboo can be pulled out. (dont try too hard, or you will ruin the cigar) if it doesnt come out , wait a couple more days. when its ready to come out, take it out, and let the cigar sit for a couple more days to let the inside mature) and smoke a couple hits.
and, when you have gotten high, cut the very end off, and then you can use that in like a bong
now, as you know, resing collects on the end closer to your mouth, so you will have extra potent weed and the mouth-end. you can smoke that part in a bong

I know this is crudely put together, but what do you think?
ethsfreshman Reviewed by ethsfreshman on . How to make a marijuana cigar Okay, i saw this on some website, but here is genreally how its done Okay, you take like a thin piece of bamboo, and some pot oil, and start wrapping destemmed leaf strips around it. do that until it is reasonably thick, okay? then you take some fine ground marijuana, mix some resin into it and paste it on the cigar. now you take more leaf strips, and pot oil, and continue wrapping. then you take your cigar, and leave it in a dark, humid area for a couple days, and check and see if the Rating: 5