Activity Stream
227,828 MEMBERS
11172 ONLINE
greengrassforums On YouTube Subscribe to our Newsletter greengrassforums On Twitter greengrassforums On Facebook greengrassforums On Google+
banner1

Page 2 of 2 FirstFirst 12
Results 11 to 20 of 20
  1.     
    #11
    Junior Member

    rolling joints...?

    im from britain, so i use tobacco in my joints, so i'll tell you how I roll:

    first i get a piece of card (something like a train ticket will work fine), fold it once (longways... yeh... longways....) and then again, then unfold it so that you have a nice stand. the stand should have two slanted sides and then a nice slanted indent right down the middle where you can put your paper. then put your paper in that indent with the glue on the side furthest from you, then get some cardboard (part of your rizlas packet will do) and roll it up, and put it at the bottom to form the roach. then start putting your tobacco in the joint smoothing it evenly down the paper, then do the same with the weed. then pick up your paper, and gently roll it between your fingers until the weed and tobacco are spread evenly, then begin to roll your joint (try to get the very corner of the paper under the other side and roll the rest into it). usually this will produce a small cone that goes about 2/3 up the paper. from then on i simply mix weed and tobacco on a nice clean table, then start filtering it into the joint. when youve got it done, simply twist the end to close it up (possibly cut a little off if its too long) and then push it down.

    then admire your artwork!

  2.   Advertisements

  3.     
    #12
    Senior Member

    rolling joints...?

    yeah man its all practice practice practice...

    my first joints were thin and shitty, now theyre textbook.

  4.     
    #13
    Senior Member

    rolling joints...?

    just spend 5 bucks on a roller i just picked up a nice metal one because i was afraid my plastic one would get broken in my pocket when i carry it with me it saves time and is easier then doing it by hand

    just open the roller put the weed in and use your fingers to even it out close the roller and spin the rollers once around to tighten the weed then insert the rolling paper i use 79mm zig zags spin the rollers again untill only the glue is showing lick that then continue rolling all the way around again then you just wait a second for the glue to dry and open the machine up take out the joint then i pinch the ends shut so no weed falls out of sides

  5.     
    #14
    Senior Member

    rolling joints...?

    Screw joints just just use your pipe. Joints just use up more of our weed ands its not as fresh if your saving it for starting it up later. I have a friend that went on a rolling crazy for about a month or a month and a half and he burned a hell of a lot more weed then he needed too.

    Rolling really isn't all that hard and its a lot easier if you can just watch a person role one first.

    A good starter way is to put the paper in a dollar bill and put the weed in there nice spred out so that when you role it up it will look uniform. Next you will take the dollar and start to move it so that the paper and weed inside start to role up... idk I suck at explaining. It would be easier to show.

  6.     
    #15
    Senior Member

    rolling joints...?

    I like joints mroe....pipe gets you mmore fucked up, but nothing compares to passing the joint, and just hanging out with friends.

  7.     
    #16
    Senior Member

    rolling joints...?

    for beginer, buy a pak of zigzags, roll one around a pen, slide the pen almost completely out. now you should have a paper roll with pen in one end a half inch, slide bud in through other opening, every so often compact it by sliding a nother pen on the other side and squeez the bud. repeat till 1/4 inch left to fill..now twist the ends and u have a compact joint

    hope that helped

  8.     
    #17
    Junior Member

    rolling joints...?

    You can use reciepts to roll joints as well, although some dont work too well since theyre too thick. The ones from small grocery stores work damn well.

  9.     
    #18
    Member

    rolling joints...?

    Quote Originally Posted by sanitisethis
    im from britain, so i use tobacco in my joints, so i'll tell you how I roll:
    What? Just because you are from Britain doesn't mean you have to use evil tobacco in your joints. I am from Britain and I never use tobacco (apart from a tiny blob down by the roach that I don't smoke). Chop or grind your herb finely enough and there is no problem rolling it. If you want to smoke less, make it thinner not weaker.

  10.     
    #19
    Senior Member

    rolling joints...?

    man, if you're 18 and you can't roll a blunt, go down to quicktrip or any old gas station and pick up some cyclones pre-rolled blunts. they're the bomb if u cant roll.

  11.     
    #20
    Senior Member

    rolling joints...?

    I like the pipe......it hurts my heart to much to watch the weed burning up..
    besides I think the pipe makes it last alot longer.....

Page 2 of 2 FirstFirst 12

Similar Threads

  1. Relatively new to rolling my own joints
    By Leardo in forum GreenGrassForums Lounge
    Replies: 22
    Last Post: 12-17-2010, 06:06 PM
  2. Rolling Joints
    By Exquizit in forum Marijuana Methods
    Replies: 14
    Last Post: 07-05-2008, 02:22 PM
  3. rolling joints
    By totalposer77 in forum Marijuana Methods
    Replies: 12
    Last Post: 07-26-2005, 07:50 AM
  4. Rolling Joints
    By thatone420kid in forum GreenGrassForums Lounge
    Replies: 6
    Last Post: 05-16-2005, 09:48 AM
Amount:

Enter a message for the receiver:
BE SOCIAL
GreenGrassForums On Facebook