Ice, that's precisely the info I was looking for. Unfortunately, I just purchased 10 L of grow with the micro/bloom order. Oh well...

I've heard a lot about using a low ppm when first planting (say 500ppm) and working up to maximum amounts later, what I'm not sure of is should the micro/grow/bloom first be 500ppm total before adding the other additives?

I've interpreted that this is the case but would appreciate verification.

and...what's the aproximate maximum ppm range for an indoor grow reaching 6ft at harvest? Strain chosen was dictated by maximum height. Assuming all available light and nutes.

Thanks again

GM