clone help?

[turtle420]

I have a female that is well developed and I want to take some clones from her. What do I need to cut and from where on the plant...then what...rootone and stick back in dirt??

Ok dude, this is going to be a super-mega-duper cloning crash course... money not refundable.

1. Cut off a secondary growth (couple of inches 4-6)
2. Cut off its lowest leave sets (leave only top, small leaves... not big leaves)
3. Submerge the cutting under water, re-cut 0.25" above original cut at an angle
4. Stick lower part of cutting into rooting hormone
5. Place under one CFL (no intense light)
6. Use DIY Bubble Cloner


Bubble Cloner
1. Use a small "tub" (one of those rigid Ziploc containers)
2. Make holes on top of container, insert the cuttings and "hold them" in place... be creative
3. Fill up Ziploc container with clone nutrient mix... fill it up UNDER the lowest part of the clones... 0.5" - 1.0" under the cuttings ... they should NOT be touching the water
4. Place airstone @ the bottom of the Ziploc container... run airpump 24/7
{{When the bubbles rise, they "pop"... this pop "sprays" the cuttings' undersides with nutrient mix}}

Hope that helps,

-turtle420
.

BTW: OverGrow is down... no access to their FAQs...

turtle420 Reviewed by turtle420 on 02-03-2006. clone help? I have a female that is well developed and I want to take some clones from her. What do I need to cut and from where on the plant...then what...rootone and stick back in dirt?? Rating: 5