bending/budding

[JokerDooD]

always a good idea test with the back of your hand when moving the light closer to the plants .place hand at top ov the plant for a min or so an if its hot , lights to close ..

sorry ur tomato plants are a little crispy .but it was still good advice from GN.

we live n learn :rasta:

[Dutch Pimp]

Bend them over for one week, using plastic tie-wraps, then release them. I found 12 inches high enough spacing for a 400HPS, IF you have a constant air supply going between the light and the plants.

[amstron]

ive had the new light on for like 8 hours, and itt burnt all the top of my plant to a fucking crisp, niceone about the 6 inches away info... that was real good 0_o

so, you worked out the adequate ventilation needed if the light was going to be this close, and you cheked the temperature so that you wouldnt do exactly what you have done.

[WeedyBoyWonder]

gah, the plant is going to have to be bent.

please give some info on the best way, do i just get a piece of string and tie it round the top of the plant and attach it to somwhere like this / ? (i have no idea ^_^)

[JokerDooD]

if ya cant tell how to bend / tie down a plant by the pic i posted then ur in for a ruff ride man,

check me post above an click on the pic very easy to do as u can see ..
:rasta:

[the last stand]

sorry ur tomato plants are a little crispy .but it was still good advice from GN.

how was it good advice, when it burnt our plant to fuck?!

[JokerDooD]

it was good advice becoz , its good advice to have ur light as close as poss to the plant top without burnin it ,that = good advice. :rasta: