Cutting a hole in glass

[420purplehaze420]

that sounds badass, hows it work?

The screwdriver and electrical tape way? you just get your glass bottle and rap it up really tight in electriacal tape(this helps prevent spider cracking)

then you cut out a circle of the tape where you want the stem or downtube to go (can only be one hole in the bottle, weakened glass cant handle 2 holes)

then put the bottle in a towel in your lap and then start to stab the bottle with a pointy screw driver with moderate force, youll start to see little white cracks after a minute or 2 and eventually a little hole will pop through in the glass. Then just chip away at the hole until its the right size.

once you carefully peel off the tape there shouldnt be to many cracks coming from the main hole but if there is its not to bad it will still work. rinse the bottle well to get rid of all glass particles and seal it all up with a hot glue gun or silly puddy or any of that type of stuff

ive only had probably 3 out of atleast 50 bottles break while i was making the holes for normal bongs and pissers. The thin fruit juice bottles work really good i find, but this way doesnt compare to a diamond drill bit and a drill press

hope this brings someones homemade bong making to the next level

peace

420purplehaze420 Reviewed by 420purplehaze420 on 01-22-2006. Cutting a hole in glass I recently purchased a beautiful green glass bottle type of thing. Its about 4 feet tall, has a very long slender neck (about 1.5 inches wide) that takes up most of the length, then at the last 8 inches it opens up into a perfectly round base about 8 inches in diameter.. Its smooth thick jungle green glass and heres the best part: i got it for $2 at a garage sale... I want to turn it into a bong Since it was not made for that purpose, it only has one hole, and thats the opening at the Rating: 5