I recently purchased a beautiful green glass bottle type of thing. Its about 4 feet tall, has a very long slender neck (about 1.5 inches wide) that takes up most of the length, then at the last 8 inches it opens up into a perfectly round base about 8 inches in diameter.. Its smooth thick jungle green glass and heres the best part: i got it for $2 at a garage sale...

I want to turn it into a bong

Since it was not made for that purpose, it only has one hole, and thats the opening at the top... I need to make 2 more, nice, clean, smooth holes in it at the base for a bowl and a carb.

So heres my question: How can i do this? Ive been told to use a high speed drill with a special glass bit, but i dont have either of those... Is there another way? i want it to be fool proof because i will go on a phychotic killing spree if it breaks; its such an amazing find.

Any advice will be greatly appreciated..
ichaseclowns Reviewed by ichaseclowns on . Cutting a hole in glass I recently purchased a beautiful green glass bottle type of thing. Its about 4 feet tall, has a very long slender neck (about 1.5 inches wide) that takes up most of the length, then at the last 8 inches it opens up into a perfectly round base about 8 inches in diameter.. Its smooth thick jungle green glass and heres the best part: i got it for $2 at a garage sale... I want to turn it into a bong Since it was not made for that purpose, it only has one hole, and thats the opening at the Rating: 5