Results 1 to 10 of 14
-
01-14-2006, 09:52 PM #1OPSenior Member
Pot Boxes, and what to carve into them.
What do you use as a pot box? Describe it.
I made mine last night. It is about the size of a thin paper-back book. It a box that is seperated in the middle by a wooden wall (I made it out of an emptied-out knife box). I keep my baggy and few pre-rolled joint on the left side. I keep the equipment on the right. The equipment is my one hitter, a small bix lighter, papers, and visine.
On the outside cover I carved a large marijuana leaf. It loks really nice.
There is about a centimeter of space left both above and below the leaf, and a few inches on each side.
Anything else that easily carvable that I should put, or should I keep with the clean and simple look of just a leaf?Jesse DeForest Reviewed by Jesse DeForest on . Pot Boxes, and what to carve into them. What do you use as a pot box? Describe it. I made mine last night. It is about the size of a thin paper-back book. It a box that is seperated in the middle by a wooden wall (I made it out of an emptied-out knife box). I keep my baggy and few pre-rolled joint on the left side. I keep the equipment on the right. The equipment is my one hitter, a small bix lighter, papers, and visine. On the outside cover I carved a large marijuana leaf. It loks really nice. There is about a Rating: 5
-
01-14-2006, 10:34 PM #2Senior Member
Pot Boxes, and what to carve into them.
paint it, boy
-
01-14-2006, 10:55 PM #3OPSenior Member
Pot Boxes, and what to carve into them.
Well, it's painted a fancy red, and carving into it reveals a very complimenting, light colored wood.
Therefore, I'd rather not paint it.
-
01-14-2006, 11:18 PM #4Senior Member
Pot Boxes, and what to carve into them.
I'd say leave it as-is. Because whenever I do something like that, I'll do something that looks really cool, and then I'll do it a bit too much, and make it end up looking crappy.
-
01-14-2006, 11:55 PM #5Senior Member
Pot Boxes, and what to carve into them.
I SAID PAINT IT BOY
-
01-15-2006, 12:03 AM #6Senior Member
Pot Boxes, and what to carve into them.
lol if u already got a nice-lookin pot leaf, just leave it. simplicity is beauty.
-
01-15-2006, 01:51 AM #7Senior Member
Pot Boxes, and what to carve into them.
i say carve a mushroom into it, unless uve never done them. i would though.
-
01-15-2006, 06:17 PM #8Senior Member
Pot Boxes, and what to carve into them.
i made a wooden stash box its 10 inches wide 12 inches long and i just stained it cherry red. then put a lock on it and put that key from the lock and put it on a rasta necklace its tight.
-
01-15-2006, 10:03 PM #9Senior Member
Pot Boxes, and what to carve into them.
i use a computer game box but i've done a few modifications to it to conceal the smell and keep it tightly closed when it is closed... works pretty well but after a few months i have to switch computer game boxes because it gets worn down
-
01-17-2006, 02:03 AM #10Senior Member
Pot Boxes, and what to carve into them.
Mine's a wooden box where the top flips open on two hinges. Inside I have a small bong, small pipe, eye drops, axe, altoids, etc. I have my stash in a tupperware container. I even put some foam weather stripping I found in the basement around the edge so when you latch the box, the top squishes down on the foam and seals air tight. The latch has a small loop for a luggage lock. Bet no one can guess the three digit number I came up with for the combination.
Advertisements
Similar Threads
-
Litter Boxes
By gypski in forum Growing InformationReplies: 1Last Post: 02-19-2009, 07:22 PM -
renting PO Boxes?
By rmrdr716 in forum GreenGrassForums LoungeReplies: 4Last Post: 08-13-2007, 06:29 PM -
Kif Boxes
By Phife in forum GreenGrassForums LoungeReplies: 1Last Post: 02-22-2006, 04:20 AM -
2 boxes of DexAlone
By MiddleburgsBum in forum Other PsychotropicsReplies: 4Last Post: 06-10-2005, 09:06 PM