Dude here is an easy way to make a decent smoking device. Here goes.

1. Find a plastic pop bottle and cut a hole in the side about the size of a quarter
2. Poke another small hole somewhere else on the side that you can cover up with your finger.
3. Get some aluminum foil and put it over the bigger hole and indent it into a small bowl.(Make sure its in pretty air tight and secure.)
4. Take a toothpick of pin and poke about 5-6 holes in the foil bowl.

Now how it works. Put the weed in the bowl. Have a lighter ready. Put your finger over the smaller hole. Light the weed as you suck in slowly and wait until the pop bottle fills with smoke. Take your finger off the small hole and inhale all the smoke. Repeat until fucked.
DrinkTheBongWater Reviewed by DrinkTheBongWater on . hey i need some advice i have never smoked weed before. i was wondering the easiest way to make a bong or a joint or whatever. i just need to know the most simple way, because i am new to all of it. could somebody give me directions or instructions on how to make one really easily. i also heard that you could make one with just a pop can and indent it in the middle with a book side, then poke holes on the indentation, then just start the weed on fire when it is over the holes. but i dont know if that is the Rating: 5