bong help

[rollinKansas]

coulsdn't he heat the glass with one of those little torches, i think they usually have a green tank about the size of a football.. just heat the shit otta one spot and you should be able to poke through, unless it's not hot enough. i know it takes a LOT of heat to melt glas but you may be able to soften it up alot.

[ilikewom]

just use a plastic bottle man. it's much easier, quicker and its the same smoke ...

[homemade]

i used a glass a hammer and a nail

tap,tap ...tap,tap,

dont hit hard, and when u do start to get a lil divet (hole starting) stop..BE EXTREMLY CAREFUL! one wrong move and the hole things wrecked, use a knife with a sharp strong tip...use it like a screw driver and dig into the divet, a hole will soon be dug...be very slow....REMEMBER DON'T USE A LOT OF PRESSURE..takes a long time to perfect...you probly will fuck up on the first one

[homemade]

just use a plastic bottle man. it's much easier, quicker and its the same smoke ...

100% correct...1000000000X easier with plastic bottles and there easy to make airtight seals

[50BagOfGreens]

havent got the glass bit yet but how did u pull off the hammer and nail thing

dont smash it just tap it lightly untill it gose thru, but not too lightly, but not too hard, but make sure its not too lightly

[GanjaBob]

yeah i just got a glass bit today and gonna try it tonight , and i have made many a bong out of plastic bottles but i just think it would be badass to have a glass one

[Goodman3eb]

Some advice:

Go very slowly! Like, way slower than you think you need to, and apply hardly any pressure at all, ESPECIALLY when the tip has already broken partially through.

Always drill STRAIGHT into the glass, and not at an angle. Drilling at an angle means you tend to slide, shake, and unevenly grind away the glass, all things that tend to break the glass.

Be creative! There are lots of things you can turn into a kickass bong when armed with a glass drillbit and some patience. I had this really cool glass jar shaped like a snowman (it was from some cutesy farmer's market maple syrup my mom bought) that I turned into a bong--perfect for the holiday season, neh?

Good luck!

[P.E.N.G.U.I.N.]

Some advice:

Go very slowly! Like, way slower than you think you need to, and apply hardly any pressure at all, ESPECIALLY when the tip has already broken partially through.

Always drill STRAIGHT into the glass, and not at an angle. Drilling at an angle means you tend to slide, shake, and unevenly grind away the glass, all things that tend to break the glass.

Be creative! There are lots of things you can turn into a kickass bong when armed with a glass drillbit and some patience. I had this really cool glass jar shaped like a snowman (it was from some cutesy farmer's market maple syrup my mom bought) that I turned into a bong--perfect for the holiday season, neh?

Good luck!

It'd be fucking badass to have a glass/ceramic/clay frosty the snowman statue that's cheap and hollow inside, and make a hooka out of it. I mean, how great would X-mas with your friends be if you're in the kitchen with this statue of frosty and four hoses coming out of his hat or something and the weed goes in his charcoal nose or mouth or something?

[Synthesizer Man]

Get your smallest drill bit, place it where you want the hole, whack it gently with a hammer, then drill through.