RIP OBD is correct- everybody else just taught you how to make a gravity bong. Its called a waterfall bong b/c the water falls out of the bottle like a waterfall. Here's what I do differently. I use a one liter coke bottle- drain it- melt a hole (a little smaller than the tip of your thumb) through the bottom/side on one of those little knots that make the bottle stand up. Then you make a bowl out of tin foil- poke a couple of pretty big holes in the bottom of your bowl. Then you pack your bowl with the herb.
Fill your bottle with the water while holding your thumb on the hole at the bottom. (to plug it from draining) Then you tighten your bowl onto the top of the bottle, making sure its tight- if it isn't air will leak out there, and you lose smoke. Then you hold the flame on your herb until it looks good and lit,now you release your thumb at the bottom. As the water leaks out- it creates a vaccuum, pulling the smoke into the bottle. It may take some practice to get the smoke to fill really thick. Once your bottle is full of smoke, plug the bottom back up with your thumb- take off your bowl carefully, making sure not to spill weed. Then you sit back and enjoy a couple of HUGE hits. Make sure to use the hole at the bottom as a carb when you inhale.
Anyway- fool proof instructions. I hope you enjoy it! I know I do. haha
Shai Hulud Reviewed by Shai Hulud on . Waterfall Bong? I need some help dudes. What is a waterfall bong and how can I make one with stuff around the house? Rating: 5