I am hoping that these take good, because this will make growing in hydro even easier thatn it already is!

Anyway we now have to place the rapid rooter into the hydroton filled netpot.
1. Place enough hydroton in bottom of netpot to allow top of rapid rooter to come about a 1/2 inch below rim...
2. carefully backfill hydroton around rapid rooter until you have a layer of hydroton covering top of rapid rooter...this allows you to add another layer, once the seedling has cleared the rim of netpot.
3. when you place netpot in DWC...make sure water level is right up to the bottom of netpots...insuring that air bubbles/water will soak hydroton and moisten rapid rooter.
4. Set netpots in DWC system and adjust lights...

5. some EYE CANDY:dance:...A table of trim from my PHAZE II cloning experiment...Still have 3 of the main kolas left hanging in the main room...the small kola on the middle right metal screen is a SKUNK that I inherited. Did a flower/finish and clone from this family...OK smoke, waiting on cure?/...Re-vegging 'mother for this.../...deep white oval container is the top 80% of my Orchid mix experiment...this is a nice smoke...small yield,
also re-vegging this plant for mother...Once I have mothers, I will stop growing from seed and just clone, clone, clone...
...tidbits...
I am just Rambling; :stoned: waiting for my attachments. This should be a fun grow...when they veg, I am going to transfer them to aero/drip system...

I just ordered 3 twirling sprinklers :dance: I can't wait for them to come in...
OK, folks, I will keep you updated...will all five sprout?...will they all live?...
Well...I wonder...hmmm, latewood