Making a wooden pipe

[ibreakthings]

So far I have taken a wooden block, drilled a hole 4/5 of the way down and then drilled a hole from the top. Im planning on using my knife to carve the rest of it off so that it actually looks like a pipe.

After I'm done, is there anything I can coat it with to keep it from burning the wood as im toking? Cuz you know....Wood smoke isnt tasty and weed is. Also do you think I should make a carb or is that un necessary because I usually hold the carb the whole time I;m hitting it....I just dont see why I gotta use it. Thanks.

ibreakthings Reviewed by ibreakthings on 10-17-2005. Making a wooden pipe So far I have taken a wooden block, drilled a hole 4/5 of the way down and then drilled a hole from the top. Im planning on using my knife to carve the rest of it off so that it actually looks like a pipe. After I'm done, is there anything I can coat it with to keep it from burning the wood as im toking? Cuz you know....Wood smoke isnt tasty and weed is. Also do you think I should make a carb or is that un necessary because I usually hold the carb the whole time I;m hitting it....I just dont Rating: 5

[P.E.N.G.U.I.N.]

i don't see the point of a carb in small pipes...but i don't know about coatings. sorry

[ibreakthings]

actualy i just realized i fucked up.. the hole isnt above the tubey part so if i were to pack it only like half of it would get lit since the sucking wouldnt hit the side thats not close to the tubey part.............................................. ....nvm

but I think im just gonna take a metal bowl thingie and hot glue it to the hole so that all of the weed gets smoked

im a dumbass









ne way thanks.... ill post a pic after im done if i can.

[P.E.N.G.U.I.N.]

good boy. learn from your mistakes, and your mistakes become Wisdom.

[benny123]

yeah definately do not put a carb on a wooden pipe, carbs are only for pipes and bongs with a chamber you can fill with smoke

[420purplehaze420]

the only way to properly resinate a wooden pipe is to smoke fat bowls with really nice weed so that the wood gets lots of resin on it and then eventually it will be a top notch smoking device its just the first couple uses that taste like shit, but i dont do the pipe game anymore me lungs done allow it, its small bong rips and joints for me

[stothelutz]

Haha me and a friend did the same thing but the lazy way. We used this huge stationary drill and a round bit to make the bowl and a regular drill bit for the hole where you suck. Works ok but I'de rather a glass pipe anyday.

[nickx760]

wheres the picture, BITCH?!?!

[P.E.N.G.U.I.N.]

Give him time on the picture...He still needs to finish it, duh.

[leatherback]

just bend a PBR 12 oz. can in half and punch holes in the top. load a bowl and proceed to get high. that gives you more time to enjoy the weed rather than being creative. However, once stoned begin your creative exploration with your wood .