Quick question about the Nutes.. I am using the Gen Hydro equivelant of everything you have mentioned in your thread (Only using genhydro because I had already bought the nutes before I found this thread!) My question is this.. I am using the "Drain To Waist" feeding method which to my understanding is typically used for growing in soil (IE: the Nutes are not re-used). The problem I am having is the conflicting info regarding the PPM. Throughout the whole plant life cycle, the feeding schedual doesnt get any higher than 600-800 PPM? I see that you typically set your Co2 to the same value as the ppm in your nutes.. so Im just wondering if you are using a Recirculating feeding schedual (for hydroponics)? The ppm on the recirculating schedual seem to match the 1200-1500ppm that I commonly see in these forums.. Just wondering if someone could clear this up for me? Should I be doubling my nutes?

Thanks!!
XXXJAYXXX Reviewed by XXXJAYXXX on . "THE SEALED ROOM" 3lbs A LIGHT THE SEALED ROOM Listen im not very good at writing this stuff down. You can post reply's with any specific questions and I will answer them best I can. My pictures of my room are 1 week from cutting down. Based On A 4 Light Room. Pictures are of a 8 Light Room. I start by sealing my room as best I can. From there I start by building a 8ft by 8ft box with 2x6. Then I screw 2 sheets of OSB 4x8 sheets to the bottom (sort of like a water bed box). I line the inside with polly making Rating: 5